The 6mm BR cartridge and its variants are legendary in the rifle competition world for their inherent accuracy, easy loading, long barrel life and low cost to shoot. The only hitch was making the cases feed and function in a repeater. Part of the problem is the ejection cycle but for those with actions that can handle the small case feeding them into the chamber is the next issue.
The Patriot Valley Arms magazine conversion kit offers shooters the option to use standard AICS 10rd magazines with new internal components. These kits take only the most modest of tools (a plastic or rubber mallet) and less than a minute of time to convert the magazines back and forth from full length 308 size cartridges to shortened 6 BR type rounds.
The Patriot Valley Arms kits feature anti-tilt legs on the fore and aft ends of the new follower, a guiding channel to keep the follower from "wandering" through the magazine body and rolling left to right during stacking. They also feature Patented DirtSwipe (TM) geometry to aid magazine reliability in dirty, dusty, or otherwise adverse conditions.
These kits are fully CNC machined from high lubricity plastic and feature heat treated, wound wire springs for a lifetime of use. The internal length change supports cases up to ~2.53-2.55" (mag bodies vary from part to part).
Videos Hide Videos Show Videos
10 Reviews Hide Reviews Show Reviews
Best mag kit on the market
Works great! Fast service and follow up.
Works great for my .20 PPC!
I ordered these to run 6 Dasher in my new AICS Mags. When I unpackaged them and started installation I noticed that the small hole that the end of the spring is supposed to fit in was not there. I had a PRS match in two days and needed to figure it out. I drilled a.050 hole on the area it needed to be and started installation. All seemed to be working fine until I started to load and shoot then I realized that the follower was binding and not keeping pressure on the rounds so that they would feed properly. At this point I was disgusted and put my original parts back into the magazine so I could make it to the first stage on time. I have emailed Josh at PVA and have had no response as of yet. In his defense he may be getting ready for SHOT so I will give it more time. All I can say at this point is that I received 2 incomplete products that were advertised to be the highest of quality. I am going to await PVA’s response as are some of the shooters in my squad. Hopefully we can resolve this and move on. On a good note they were packaged well and shipped fast.
I built a 6 BRX for PRS competition. Have not been able to get it to feed out of a magazine yet, until I bought these. Excellent product it really smooth up the bolt when all 10 rounds are in as well.
Great Kit. Top notch product. Makes loading ACIS mags with 10 rounds a breeze. Never had a problem feeding 1st through 10. Definitely a winner
Love this product, if you need to feed a BR/dasher from a mag this will do the trick, slick set up and works on 5rnd mags as well! Just get a 5rn aics mag in 308 and with a die grinder with cut off wheel cut the back bone down and take the spring down a little at a time. Feeds perfect will order more
This is a good solution for the br dasher feeding problem. Very well thought out and executed.
I must say that this kit fit and functioned perfectly in my 10 rd AICS and Accurate Mag magazines. The thought and design ofr the interlocking follower into the spacer to allow for smooth even pressure on the cartridges from the first to the last is perfect